Xerox ApeosPort C6550 I Network Administrator's Manual page 33

3
Configure the following items as necessary.
Print Mode
Configure the print language on the machine to match the received data.
JCL
Enable when receiving a job using JCL commands.
The JCL commands are independent of any print languages. A print language used
in the next data can be set independently of the current print language.
Auto Eject Time
Configure the time that the data so far received by the machine will automatically be
printed since data is no longer sent to the printer.
Adobe Communication Protocol
Configure the protocol defining the communication method between PostScript
printers and a host.
Note
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out a settings list to confirm that the USB port is
enabled.
For information how to print a setting list, refer to "Print Report/List" in Chapter 12 of the User Guide.
Configuration on the Computer
The following describes the configuration procedure for the computer.
In order to print from the machine, the computer needs to have a print driver installed.
For information about the supported operating systems, refer to "Supported Operating Systems" (P.16).
For information about the driver installation procedure, refer to the manual contained in the CentreWare
Utilities CD-ROM.
You can also print from a Macintosh using USB. You will need an optional PostScript3 kit. Refer to the
manual contained in the CD-ROM provided with the machine for the print driver installation procedure.
• Adobe Communication Protocol can be set only when an optional PostScript3 kit is
connected.
Installation Procedure
31
3