Configure A Room Designer Project - Crestron 1 Beyond Automate VX Series Product Manual

Configure a Room Designer Project

The following settings are provided for configuring a Room Designer project.
General Settings
Select the Settings tab on the left-hand side of the Room Designer page to access the following general
Room Designer settings.
Settings Tab
Set Scale
Set the scale for the room to provide the Automate VX a reference to the room size.
To set the scale of the Room Designer project:
1. Select the Set Scale button. The mouse cursor acts as the beginning point of a measurement line.
2. Navigate the mouse cursor to a point in the room where the length or width of the object (for
example, a conference table) is known.
3. Click once on one end of the object that is being used as a reference. There will now be a red line
attached to the start point that was clicked.
NOTE: Holding shift while using the Set Scale tool will lock the red line to 90-degree
increments.
35 • IV-SAM-VXN-1B, IV-SAM-VXP-1B, and IV-SAM-VXS-1B Product Manual — Doc. 9324F