Table of Contents
Advertisement
Configure Audio
Audio input to the Automate VX is not required for voice-activated camera switching. For video
conferencing, send audio directly from your DSP to your codec with a 400ms delay in order to ensure
proper lip sync.
For local recording or streaming with the system, activate the installed Dante Virtual Soundcard by
purchasing a license from www.audinate.com. Alternatively, use the line in input on the system rear
panel for an analog signal flow.
DSP Configuration
Automate VX can utilize a DSP to route audio logic from microphones for AutoSwitching. For more
information about AutoSwitching, refer to
Designer must be configured along with the DSP. For more information about the Adjudication settings
inside of Room Designer, refer to
Use the following procedures to configure the respective DSP for Automate VX.
QSC Q-SYS™ Core Configuration for Automate VX
The following items are required to integrate a QSC Q-SYS™ Core DSP with Automate VX:
IV-SAM-VXS-1B, IV-SAM-VXP-1B, or IV-SAM-VXN-1B.
l
QSC Q-SYS Core 110F, QSC Q-SYS Core 510i, or QSC Q-SYS Core 610.
l
A computer with the latest version of Q-SYS Designer software.
l
Before configuring the QSC Q-SYS Core DSP to communicate with Automate VX, complete the
following procedure to open the Q-SYS Designer project file:
1. Open Q-SYS Designer software on a computer. Ensure that it is the newest version of the
software.
2. Select File in the top left corner of the software.
3. Select Open, then select the project for the room that is going to be used with Automate VX.
Gating Mixer
A Q-SYS Core DSP requires a legacy gating mixer block to properly communicate with Automate VX.
Complete the following procedure to add a legacy gating mixer to the Q-SYS Designer project:
Product Manual — Doc. 9324F
Main Menu on page
Adjudicator Settings on page
161. The Adjudicator settings in Room
51.
IV-SAM-VXN-1B, IV-SAM-VXP-1B, and IV-SAM-VXS-1B • 114
Advertisement
Table of Contents
