Connect To The System - Crestron 1 Beyond Automate VX Series Product Manual

3. Connect each PTZ camera to the SDI® ports of the Automate VX device using HD-SDI cables.
Ensure the numbered SDI port corresponds to the camera number determined in step 1.
NOTE: Each PTZ camera should be connected to a network switch via Ethernet and can be
powered via PoE+ (Power over Ethernet Plus) with 30 W power.
4. Connect the NIC 2 port on the camera switching device to the network switch via an Ethernet
cable.
5. Connect the DisplayPort™ computer monitor output to a display (either directly or through a
matrix).
6. To perform initial device setup, either connect the NIC port to a computer for remote desktop
control, our use a mouse and keyboard for direct control. For more information, refer to
to the System on page

Connect to the System

For initial setup, either connect the NIC 1 port to a computer for Windows® Remote Desktop, or use a
mouse and keyboard for direct control.
To connect directly to the Windows Remote Desktop:
1. Connect to the NIC 1 port of the camera switching device to a computer.
Camera Switching Device Ethernet Ports
2. Set the following static IP and subnet addresses on your computer:
IP address: 10.1.10.1
l
Subnet address: 255.255.255.0
l
21 • IV-SAM-VXN-1B, IV-SAM-VXP-1B, and IV-SAM-VXS-1B
21.
Connect
Product Manual — Doc. 9324F