Basic Operation; Main Menu - Crestron 1 Beyond Automate VX Series Product Manual

Basic Operation

The following procedures describe how to operate the basic functions of the Automate VX. For
information on how to enter the web user interface, refer to
page 93.
When the web user interface is opened, there are five main tabs that control the operation of the
Automate VX system. The contents of these tabs are explained below.
NOTE: Before using these controls, ensure that the Automate VX is configured to the desired
specifications. For more information on how to configure the Automate VX, refer to
Configuration on page 93

Main Menu

Select the Main tab to view and perform common functions for the Automate VX.
Main Menu Selections
Select AutoSwitch to start and stop automated switching. AutoSwitching is the Automate VX using the
Virtual Mic positions from Room Designer in conjunction with the Microphone Device to switch camera
shots automatically. The software only communicates with Microphone Devices when AutoSwitch is
activated. For more information on setting up a room layout in Room Designer to ensure the best
AutoSwitching performance, refer to the
161 • IV-SAM-VXN-1B, IV-SAM-VXP-1B, and IV-SAM-VXS-1B
and Room Designer on page
Room Designer on page 29
Access the Web Configuration Interface on
29.
section.
System
Product Manual — Doc. 9324F