Initial Setup; Assign Network Interfaces; Set Static Ip Addresses - Crestron 1 Beyond Automate VX Series Product Manual

Initial Setup

Use the following procedures to set up the Automate VX following installation.

Assign Network Interfaces

Automate VX has two NICs labeled Ethernet and Ethernet 2. The Ethernet ports have the following
default addressing configuration:
The NIC 1 port is set as a static IP (10.1.10.2) for initial configuration via the Windows® Remote
l
Desktop application.
The NIC 2 port is set to use DHCP and can be used for connecting to a network connection.
l
Set Static IP Addresses
Static IP addresses must be set after assigning the network interfaces.
NOTE: The web interface and API of the Automate VX rely on static IP addresses for the system,
cameras, and microphones. As a result, static IP address should be set during the initial setup.
Product Manual — Doc. 9324F IV-SAM-VXN-1B, IV-SAM-VXP-1B, and IV-SAM-VXS-1B • 24