Table of Contents
Advertisement
Innovative Hearth Products
DRL6500 Linear Direct-Vent Gas Fireplaces
3. To light the burner, turn ON the wall or remote control switch. Ensure the igniter lights the pilot. The pilot flame
Figure 34 - Electronic Pilot
Install the Glass Media
15.
1. See Page 58 for instructions on Installing the Glass Media.
Install the Baffle
16.
1. With the baffle oriented as shown in Figure 35, slide the rear tabs into the slots in the back panel.
Figure 35 - Baffle
2. While sliding the tabs into the slots, slide the front lip of the baffle under the clips in the firebox ceiling.
Install the Glass Door
17.
1. See Page 59 for instructions on Installing and removing the glass door.
Adjust the Air Shutter to Ensure Proper Flame Appearance
18.
• Air shutter adjustment should only be performed by a qualified professional service techni-
• Ensure glass door is in place and sealed during adjustment.
40
should engulf the flame rod (Figure 34).
Igniter
Flame
Rod
Baffle
cian.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Pilot Hood
Firebox Ceiling
Clip
Tabs
Back Panel
WARNING
Installation
900077-00, 01/2018
Advertisement
Table of Contents
