Connect The Robot And The Control Box; Figure 62: Connecting The Robot And The Control Box - Omron Regular Payload Series Hardware Installation Manual

6.4.4 Connect the Robot and the Control Box

Connect the power cable from the control box to the robot, and then connect the power cable from AC
power to the control box to boot up the controller.
WARNING:
1. Ensure that all cables are correctly connected before the control box is energized. Always
use genuine power cables correctly.
2. When the robot is turned on, do not disconnect cables of the robot. When cables of the robot
are not connected to the connection interface, do not turn on the robot.
3. Do not extend or modify the original cables of the robot.
Regular Payload Series-Hardware Installation Manual TM5 Series

Figure 62: Connecting the Robot and the Control Box

69