6.4.4 Connect the Robot and Control Box
Connect the power cable from the control box to the robot, and then connect the power cable from AC
power to the control box to boot up the controller.
WARNING:
1. Ensure that all cables are correctly connected before the control box is energized. Always use
genuine Techman power cables correctly.
2. When the robot is turned on, do not disconnect cables of the robot. When cables of the robot
are not connected to the connection interface, do not turn on the robot.
3. Do not extend or modify the original cables of the robot.
Medium & Heavy Payload Series-Hardware Installation Manual TM12/14 Series
Figure 57: Connecting the Robot and the Control Box
62