Installing A 5.25" Drive - Siemens SIMATIC IPC RW-545A Operating Instructions Manual

12.Insert the drive cover ③ between the drive mounting bars ②. Ensure that the pins engage in
the openings on the left and right ⑦.
13.Push the drive bay in fully and evenly until you hear it click into the drive cage.
14.Connect the power and data cables to the drive.
15.Close the device.
7.6.3

Installing a 5.25" drive

You can install 5.25" drives in the drive cage type A and drive cage type B.
Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 47)".
• The device is equipped with a drive cage type A or type B.
• You know the information under:
– Installation options for drives with drive cage type A (Page 104)
– Installation options for drives with drive cage type B (Page 114)
• An original spare part, that is, a 5.25" drive approved for this device. You can find
information on spare parts under "Hardware accessories (Page 32)".
• Screwdriver TORX T10
Procedure
1. Fully disconnect the device from the line voltage, see "Switching off the device (Page 74)".
2. Open the device. Be sure to follow the important instructions under "Open the device
(Page 93)".
Workstation SIMATIC IPC RW-545A
Operating Instructions, 08/2023, A5E52943278-AA
Expanding and assigning parameters to the device
7.6 Installing and removing drives
119