Removing A Backplane For Removable Tray - Siemens SIMATIC IPC RW-545A Operating Instructions Manual

Expanding and assigning parameters to the device
7.6 Installing and removing drives
7. Insert the backplane ④ into the drive bay from the front and snap it into place at the back.
Check the following:
– The backplane lies flat at the back in the drive cage.
– All centering openings ⑤ of the backplane lie in the centering pins.
– The backplane is clipped in behind the latches ⑥.
– All backplanes lie exactly underneath each other, vertically aligned, when viewed from
8. Replace the required covers or removable trays on the front of the type A drive cage.
9. Insert the cover ② into the front of the device.
10.At the backplane, connect the data cables with the corresponding interfaces on the
motherboard or the hardware RAID controller.
11.Connect the power supply.
12.Close the device.
7.6.1.5

Removing a backplane for removable tray

The backplane of the removable tray is installed from inside at the back end of the drive cage
type A and is equipped with interfaces for data cables to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
112
above ⑦.
Workstation SIMATIC IPC RW-545A Operating
Instructions, 08/2023, A5E52943278-AA