Installing And Removing A Graphics Card; Installing A Graphics Card - Siemens SIMATIC IPC RW-545A Operating Instructions Manual

Expanding and assigning parameters to the device

7.5 Installing and removing a graphics card

7.5 Installing and removing a graphics card
7.5.1

Installing a graphics card

In its delivery state, the device is equipped with integrated graphics interfaces.
You will find several connection sockets on the rear of the device for connecting monitors to
these graphics interfaces.
You can find information on the position of the connection sockets and the labeling on the
device in section "Device ports (Page 20)".
To connect additional monitors to the device (multi-monitoring) (Page 63), you can install a
graphics card.
Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 47)".
• A graphics card suitable for this device that supports multi-monitoring, see "Connecting
several monitors (multi-monitoring) (Page 63)".
• You know the information about the power supply of the graphics card, see
"Technical specifications of the plug connectors for the power supply of graphics cards
(Page 157)".
• You have made a note of the firmware settings because the firmware settings of the
device can be deleted when a graphics card is installed.
You can find information on this in the firmware description of the device, see "Important
instructions and manuals for operating the device (Page 11)".
102
Workstation SIMATIC IPC RW-545A Operating
Instructions, 08/2023, A5E52943278-AA