Connecting The Device To Networks - Siemens SIMATIC IPC RW-545A Operating Instructions Manual

Procedure
1. Connect the monitors to the rear of the device (Page 20).
For information on connecting monitors with adapters, see "Hardware accessories
(Page 32)".
2. On delivery the device is set for multi-monitoring.
If the delivery state settings have been changed, configure the multi-monitoring function
in the firmware settings, see "Installing a graphics card (Page 102)".
See also
Technical specifications of graphic (Page 152)
Technical specifications of the connections on the device (Page 155)
4.5

Connecting the device to networks

The following options are available for integrating the device into existing or planned system
environments and networks.
Ethernet
Wake on LAN and Remote Boot are supported.
You can use the integrated Ethernet interfaces for communication and data exchange with
automation devices, e.g. SIMATIC S7.
You need the "SOFTNET S7" software package for this.
PROFINET
PROFINET can be operated via:
• All Ethernet ports on the device (RT)
SIMATIC NET
Use this software package to create, operate and configure an innovative network for Field &
Control level. Additional information is available under SIMATIC NET
(http://w3.siemens.com/mcms/automation/en/industrielle-
kommunikation/Seiten/Default.aspx).
The software package and the documentation are not included in the scope of delivery
Additional information
You can find additional information on the Internet at: Technical support
(https://support.industry.siemens.com)
Workstation SIMATIC IPC RW-545A
Operating Instructions, 08/2023, A5E52943278-AA
Connecting the device
4.5 Connecting the device to networks
71