Change 2.5" And 3.5" Drive In Assembly Kit For 5.25" Tray - Siemens SIMATIC IPC RW-545A Operating Instructions Manual

Expanding and assigning parameters to the device
7.6 Installing and removing drives
7.6.2.2

Change 2.5" and 3.5" drive in assembly kit for 5.25" tray

You can install 2.5" and 3.5" drives in the assembly kit for the 5.25" tray in the drive cage type
A and drive cage type B.
In this assembly kit, the drive is shock and vibration dampened.
Assembly kit HDD/SSD for 5.25" tray
Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 47)".
• The device is equipped with a drive cage type B.
• You know the information under:
– Installation options for drives with drive cage type B (Page 114)
• An original spare part, that is, an HDD/SDD assembly kit for 5.25" tray approved for this
device. You can find information on spare parts under "Hardware accessories (Page 32)".
• When replacing a 3.5" HDD: Screwdriver TORX T10
• When replacing a 2.5" SSD: Screwdriver TORX T8
Procedure
1. Fully disconnect the device from the line voltage, see "Switching off the device (Page 74)".
2. Open the device. Be sure to follow the important instructions under "Open the device
(Page 93)".
3. Remove all power supply and data cables from the drive.
116
Workstation SIMATIC IPC RW-545A Operating
Instructions, 08/2023, A5E52943278-AA