Table of Contents
Advertisement
Maximum vibration load for drives in the respective installation location
Note
If the device is permanently installed, mounted on telescopic rails or operated as a tower, it
may only be exposed to the following vibration loads during operation.
The restrictions do not apply to the use of SSD.
Drives in drive cage type B
Drives in drive cage type B may be exposed to the following maximum vibration loads during
operation:
• 10 ... 58 Hz: 0.015 mm
• 58 Hz to 500 Hz: 2 m/s
Vibrations must not exceed 500 Hz.
Possible drive configurations
You can implement the following drive configurations in the drive cage type B and on the
side panel of the device.
• Non-RAID system
• RAID1 system
• RAID5 system
• RAID1 system with hot spare drive
• RAID5 system with hot spare drive
Workstation SIMATIC IPC RW-545A
Operating Instructions, 08/2023, A5E52943278-AA
Expanding and assigning parameters to the device
2
7.6 Installing and removing drives
115
Advertisement
Table of Contents
