Juniper ACX6160 Hardware Manual page 73

1. Connect the ACX6160 to power. See
2. Connect the Ethernet RJ-45 MGMT port on the ACX6160 to your management network where your
Open ROADM controller resides. See
on page 62.
By default, the ACX6160 is set up for dynamic IP address assignment. The following process takes
place:
• When the ACX6160 powers on, it requests an IP address from the DHCP server in your
management network. This assigned IPv4 or IPv6 address is temporary and allows the Open
ROADM controller to establish initial contact for commissioning the ACX6160.
• After the DHCP server assigns the temporary IP address to the device, the device waits for the
Open ROADM controller to connect to it using NETCONF over SSH on port 830 with the default
username openroadm and password openroadm.
• If the login is successful, the Open ROADM controller configures the info container after it
connects to the ACX6160 by using the DHCP temporary IP address. The info container contains
the node-id, IP address, gateway address, and other details specific to the node.
3. The Open ROADM controller reboots the ACX6160 by using the Open ROADM restart RPC
command. The reboot is necessary for the new IP address to take effect.
4. Use the Open ROADM controller to set up the permanent IP address, change the default username
and password, and complete the initial configuration.
5. You can now manage the ACX6160 by using the Open ROADM controller.
NOTE: If at any point in time, the Open ROADM controller deletes the info container on a
node after the initial commissioning is done, the device goes into a factory default state and
the commission process is re-initiated.
NOTE: See the ACX6160 Universal Metro Router User Guide at
documentation/ for information about the ACX6160 features.
RELATED DOCUMENTATION
ACX6160 Management Cable Specifications and Pinouts | 42
"Connecting the ACX6160 to Power" on page
"Connecting the ACX6160 to a Management Ethernet Device"
54.
https:/ /www.juniper.net/
65