• When removing or installing a component that is subject to ESD damage, always place it component-
side up on an antistatic surface, in an antistatic card rack, or in an antistatic bag (see
page
129). If you are returning a component, place it in an antistatic bag before packing it.
Figure 40: Placing a Component into an Antistatic Bag
CAUTION: ANSI/TIA/EIA-568 cables such as Category 5e and Category 6 can get
electrostatically charged. To dissipate this charge, always ground the cables to a suitable
and safe earth ground before connecting them to the system.
Attention Les câbles ANSI/TIA/EIA-568, par exemple Cat 5e et Cat 6, peuvent
emmagasiner des charges électrostatiques. Pour évacuer ces charges, reliez toujours les
câbles à une prise de terre adaptée avant de les raccorder au système.
DC Power Electrical Safety Guidelines
• A DC-powered device is equipped with a DC terminal block that is rated for the power requirements
of a maximally configured device.
• For permanently connected equipment, a readily accessible disconnect device shall be incorporated
external to the equipment.
129
Figure 40 on