Table of Contents
Advertisement
Figure 57. Installing the optional IDSDM or vFlash card
Next steps
1
Install the MicroSD cards.
NOTE:
Reinstall the MicroSD cards into the same slots that are based on the labels you had marked on the cards during
removal.
2
Install the air
shroud.
3
Follow the procedure that is listed in
Removing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the air shroud.
4
Remove the IDSDM or vFlash module.
Steps
1
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the
2
Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
86
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
System board jumpers and connectors
system.
system.
section.
Advertisement
Table of Contents
