Table of Contents
Advertisement
Figure 77. Removing the right control panel
Next step
1
Install the right control
Installing the right control panel
Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the front
bezel.
4
Remove the air
shroud.
Steps
1
Route the control panel cable through the side and the guide slots in the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2
Align and insert the right control panel assembly in the slot on the system.
3
Connect the control panel cable to the system board connector.
4
Using the appropriate screwdriver, replace the screws that secure the right control panel to the system.
104
Installing and removing system components
panel.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
