Figure 70. Installing optional IDSDM module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Follow the procedure listed in
Optional IDSDM or vFlash module
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate
IDSDM/vFlash module, see the
2. Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
After working inside your system
Safety instructions
Before working inside your system
System board jumpers and connectors
on page 35.
on page 34.
on page 35.
section.
Installing and removing system components
89