Installing The Internal Usb Card; Microsd Card; Removing The Microsd Card - Dell EMC PowerEdge E75S Series Installation And Service Manual

Installing the internal USB card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Connect the USB key to the internal USB card.
NOTE: For information on the exact location of USB on system board, see
section
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 95. Installing the internal USB card
Next steps
1. Follow the procedure listed in
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.

MicroSD card

Removing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the IDSDM module.
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
system.
System board jumpers and connectors
system.
system.
Installing and removing system components 97