Table of Contents
Advertisement
Figure 50. Installing system battery
Next steps
1
Install the expansion card
2
Install the air
shroud.
3
Follow the procedure listed in the
4
Confirm that the battery is operating properly, by performing the following steps:
a
Enter the System Setup, while booting, by pressing F2.
b
Enter the correct time and date in the System Setup Time and Date fields.
c
Exit the System Setup.
d
To test the newly installed battery, remove the system from the enclosure for at least an hour.
e
Reinstall the system into the enclosure after an hour.
f
Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the
78
Installing and removing system components
riser.
After working inside your
system.
Getting help
System board jumpers and connectors
section.
section.
Advertisement
Table of Contents
