Table of Contents
Advertisement
2
Follow the procedure listed in the
3
Remove the drives.
NOTE:
To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before removing
the backplane.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1
Align the slots on the backplane with the hooks on the system.
2
Lower the backplane until the blue release tabs click into place.
Figure 62. Installing the backplane
Next steps
1
Connect the following cables to the backplane:
a
Backplane signal cable
b
Backplane power cable
c
PERC cable
2
Replace the drives.
3
Follow the procedure listed in the
90
Installing and removing system components
Before working inside your
After working inside your
system.
system.
Advertisement
Table of Contents
