Table of Contents
Advertisement
Initializing the TPM 1.2 for TXT users
1
While booting your system, press F2 to enter System Setup.
2
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3
From the TPM Security option, select On with Preboot Measurements.
4
From the TPM Command option, select Activate.
5
Save the settings.
6
Restart your system.
7
Enter System Setup again.
8
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
9
From the Intel TXT option, select On.
Initializing the TPM 2.0 for TXT users
1
While booting your system, press F2 to enter System Setup.
2
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3
From the TPM Security option, select On.
4
Save the settings.
5
Restart your system.
6
Enter System Setup again.
7
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
8
Select the TPM Advanced Settings option.
9
From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen.
10
On the System Security Settings screen, from the Intel TXT option, select On.
11
Save the settings.
12
Restart your system.
Control panel
Removing the left control panel
Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the front
bezel.
4
Remove the air
shroud.
Steps
1
Disconnect the control panel cable from the system board connector.
NOTE:
Ensure that you note the routing of the cable as you remove it from the system board.
2
Using the appropriate screwdriver, remove the screws that secure the left control panel assembly to the system.
3
Disengage the left control panel housing clip that is located at the bottom of the control panel assembly.
4
Holding the control panel assembly, remove the control panel along with the cable away from the system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
101
Advertisement
Table of Contents
