Table of Contents
Advertisement
Recommended tools
You need the following tools to perform the removal and installation procedures:
•
Key to the bezel lock
The key is required only if your system includes a bezel.
•
Phillips #1 screwdriver
•
Phillips #2 screwdriver
•
Torx #T15 screwdriver
•
Plastic scribe
•
1/4 inch flat blade screwdriver
•
Wrist grounding strap connected to the ground
•
ESD mat
You need the following tools to assemble the cables for a DC power supply unit:
•
AMP 90871-1 hand-crimping tool or equivalent
•
Tyco Electronics 58433-3 or equivalent
•
Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE:
Use alpha wire part number 3080 or equivalent (65/30 stranding).
Front bezel
Removing the front bezel
Prerequisites
1
Follow the safety guidelines listed in the
2
Keep the bezel key handy.
Steps
1
Unlock the bezel.
2
Press the release button, and remove the left end of the bezel.
3
Unhook the right end of the bezel, and remove the bezel.
40
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
