Installing The Intrusion Switch; System Memory - Dell EMC PowerEdge R240 CHRH4 Installation And Service Manual

Figure 33. Removing the intrusion switch
Next step
1 Replace the intrusion

Installing the intrusion switch

Prerequisites
1 Follow the safety guidelines listed in the
2 Follow the procedure listed in the
Steps
1 Align and slide the intrusion switch into the slot in the system.
2 Route the intrusion switch cable through the cable routing clips.
3 Connect the intrusion switch cable connector to the connector on the system board.
Figure 34. Installing the intrusion switch
Next step
1 Follow the procedure listed in the

System memory

switch.
Safety instructions.
Before working inside your
After working inside your
system.
system.
Installing and removing system components 63