Table of Contents
Advertisement
Figure 50. Installing system battery
Next steps
1.
Install the expansion card
2.
Install the air
shroud.
3. Follow the procedure listed in the
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB memory key
NOTE:
To locate the internal USB port on the system board, see the
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Locate the USB port or USB memory key on the system board.
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
Getting help
System board jumpers and connectors
system.
PowerEdge R240 installing and removing system components
section.
section.
69
Advertisement
Table of Contents
