Table of Contents
Advertisement
M800S/M80/E80 Series Connection and Setup Manual
21 Confirming the Basic Operation
21.3.2 NC Analyzer2
Servo parameters can be automatically adjusted by measuring and analyzing the machine characteristics.
Measurement and analysis are conducted by driving the motor using machining programs for adjustment or vibration
signals. Various data can also be sampled.
Control unit
NC Analyzer2
<Functions>
Adjustment wizard
Velocity loop gain adjustment
Lost motion adjustment
Measurement and adjustment
Frequency response measurement Measures the frequency response of speed loop for the designated axis. The result will be
Reciprocation acceleration/
deceleration measurement
Roundness measurement
Synch tap error measurement
Spindle acceleration/deceleration
measurement
Spindle orientation measurement
Spindle C-axis measurement
Spindle synchronization
measurement
PLC axis acceleration/deceleration
measurement
Arbitrary path measurement
(*2)
(*1) For the measurement, create a program by the program creation function or use an arbitrary machining program.
(*2) Two or more NC axes in the same system are needed.
For details, refer to "NC Analyzer2 Instruction Manual" (IB-1501501326).
Drive unit
Automatically adjusts velocity loop gain and resonance filters.
Adjusts the lost motion automatically for the delay in responsecaused when the direction of
the machine rotates is reversed.
output as frequency response waveform.
Measures the reciprocation acceleration/deceleration for the designated axis. The result will
be output as time-series waveform. (*1)
Measures the roundness for the designated axis. The result will be output as roundness
waveform. (*1)
Measures the synchronous tap error for the designated axis. The result will be output as time-
series waveform.(*1)
Measures the spindle acceleration/deceleration for the designated axis. The result will be
output as time-series waveform. (*1)
Measures the spindle orientation for the designated axis. The result will be output as time-
series waveform.(*1)
Executes the reciprocation acceleration/deceleration measurement of spindle C axis with
specified axis. The result will be output as time-series waveform. (*1)
Executes an arbitrary machining program with specified axis, and measures spindle
synchronization by using that data. The result will be output as time-series waveform.
Executes an arbitrary machining program with specified axis, and measures PLC axis
acceleration/deceleration by using that data. The result will be output as time-series
waveform.
Executes an arbitrary machining program with specified two axes. The result will be output as
arbitrary path measurement waveform. (*1)
453
Description
Description
IB-1501269-J
Advertisement
Table of Contents
