Measures For Wiring In Panel; Precautions For Wiring In Panel - Mitsubishi M800S Series Connection And Set Up Manual

Hide thumbs Also See for M800S Series:

Table of Contents

M800S/M80/E80 Series Connection and Setup Manual

37 Appx.4: EMC Installation Guidelines

37.5 Measures for Wiring in Panel

Cables act as antennas to propagate unnecessary noise, and thus must be appropriately shielded and treated.

The following measures must be sufficiently considered for the cables (J210/J303) that carry out high-speed

communication.

(1) If the cables are led unnecessary in the panel, they will pick up noise. Pay attention to the device layout and wire

length so that the wiring length is as short as possible.

Device Device

(2) Always connect the grounding wire to the FG terminal indicated on the device.

(3) Keep the distance between the drive line and encoder cable to the drive section motor as far apart as possible

when wiring.

(4) Do not lead the power supply wire around the panel without using a filter.

IB-1501269-J

M80 series E80 series M80w series