Sun Microsystems Netra CT 820 Administration Manual page 83

CLI Commands Supported on a Third-
Party Node Board
A limited number of CLI commands from the active distributed management card
support third-party node boards.
TABLE A-1
Command
poweron cpu_node
poweroff cpu_node
reset -x cpu_node
setfru [-h] target instance field value
showfru target instance field
showcpustate
For more information on using the CLI, refer to
Card Command-Line Interface" on page
CLI Commands Supported on a Third-Party Node Board
Permission
r
r
r
a
a
lists and describes these commands.
TABLE A-1
Description
Power on the specified node slot, where cpu_node can
be 3 through 20.
Power off the specified node slot, where cpu_node can
be 3 through 20.
Reset (reboot) a specified node. reset -x produces a
hard reset (resets the board), where cpu_node can be 3
through 20.
Set FRU ID information. See
Board FRU ID Information" on page 67
information.
Display FRU ID information. See
Board FRU ID Information" on page 67
information.
Display the board type, power state, and boot state
for each slot in the system. For third-party node
boards, this command returns a boot state of
"unknown".
"Using the Distributed Management
37.
Appendix A
"Third-Party Node
for more
"Third-Party Node
for more
Third-Party Node Boards 69