Administering Your System; Using The Distributed Management Card Command-Line Interface - Sun Microsystems Netra CT 820 Administration Manual

3
C H A P T E R

Administering Your System

You administer your system using the distributed management card command-line
interface, and through the MOH and PMS applications.
The distributed management card CLI works with the MOH and PMS applications,
and supports Simple Network Management Protocol (SNMP) and Remote Method
Invocation (RMI) interfaces. MOH provides the SNMP and RMI interfaces to
manage the system and send out events and alerts. CLI provides an overlapping
subset of commands with MOH and also provides commands for the distributed
management card itself; sending out events and alerts is not a function of the CLI.
This chapter contains the following sections:

Using the Distributed Management Card Command-Line Interface

I
Updating the Distributed Management Card Flash Images
I
Setting the Date and Time on the Distributed Management Card
I
Booting Node Boards
I
Connecting to Node Board Consoles from the Distributed Management Card
I
Using the PMS Application for Recovery and Control of Node Boards
I
Monitoring Your System
I
Using the Distributed Management Card
Command-Line Interface
The distributed management card command-line interface provides commands to
control power of the system, control the node boards, administer the system, show
status, and set configuration information. (See
Management Cards" on page 8
management card.)
"Accessing the Distributed
for information on how to access the distributed
37