Specifying Other Fru Id Information; Configuring The Node Boards - Sun Microsystems Netra CT 820 Administration Manual

Specifying Other FRU ID Information

You can use the FRU fields Location, Cust_Data, and User_Label to enter any
customer-specific information about your system. These are optional entries; by
default, there is no information stored in these fields. Information entered in the
Location field is displayed through the MOH application.
You might want to use the Location FRU field to enter specific, physical location
information for your system. For example, you might enter the number on the
chassis label, to indicate the location of the system.
To Specify Other FRU ID Information
M
1. Log in to the active distributed management card.
2. Specify other FRU ID information for the Netra CT server:
hostname cli> setfru fru_target fru_instance fru_field value
Refer to
TABLE 2-1
want to set the location information to reflect a chassis label that reads 12345-10-20,
enter the following:
hostname cli>
setfru midplane 1 Location 12345-10-20
3. Completely power off and on the system by locating the power switch at the rear
of the Netra CT 820 server; press it to the Off (O) position, then press it to the On
(|) position.

Configuring the Node Boards

You should verify that you can log in to the node boards. Any Solaris configuration
needed for your environment should be done, such as modifying OpenBoot PROM
variables. Refer to the Solaris documentation, the OpenBoot PROM documentation,
or to the specific node board documentation if you need additional information.
Chapter 3 contains additional information on node boards.
for allowable information for each variable. For example, if you
Chapter 2 Configuring Your System 25