Setting Up User Accounts On The Distributed Management Card - Sun Microsystems Netra CT 820 Administration Manual

4. Set the IP netmask:
hostname cli> setipnetmask -b port_num addr
Set the IP netmask of the distributed management card. The default is 0.0.0.0. This
command is only used if the ipmode is set to config. You must reset the
distributed management card for the changes to take effect.
5. Set the IP gateway:
hostname cli> setipgateway addr
Set the IP gateway of the distributed management card. The default is 0.0.0.0. You
must reset the distributed management card for the changes to take effect.
6. Reset the distributed management card.
Setting Up User Accounts on the
Distributed Management Card
User accounts are set up using the distributed management card command-line
interface. The default user account is netract and the password is suncli1. This
account is set to full authorization (permissions). This account can not be deleted;
however, you should change the password on this account for security purposes,
before your Netra CT 820 server is operational.
The distributed management card supports 16 accounts with passwords.
To Set Up a User Account
M
1. Log in to the distributed management card.
2. Add a user:
hostname cli>
10 Netra CT 820 Server System Administration Guide • March 2004
useradd username