Table 3-2 Standby Distributed Management Card Command-Line Interface Commands - Sun Microsystems Netra CT 820 Administration Manual

Information on configuring distributed management card ports, setting up user
accounts, specifying FRU ID information, and starting the PMS daemon using the
distributed management card CLI is provided in
commands are described in
of Node Boards" on page
Standby Distributed Management Card Command-Line Interface Commands
TABLE 3-2
Command
Type Command
Status
shownetwork
showdate
showhostname
showipmode
-b port_num
showipaddr
-b port_num
showipnetmask
-b port_num
showipgateway
showservicemode
CPU control reset [-h] [dmc|1B]
Administra-
logout
tion
password [-h]
44 Netra CT 820 Server System Administration Guide • March 2004
"Using the PMS Application for Recovery and Control
60.
Permis-
sion Description
Display the current network configuration of the
distributed management card.
Display the system date.
Display the value of the hostname used in the CLI
prompt.
Display the value of ip_mode for the specified
port number.
Display the value of ip_addr for the specified
port number.
Display the value of ip_netmask for the specified
port number.
Display the value of ip_gateway for the
distributed management card.
Display the value of the distributed management
card service mode.
r Reset (reboot) the distributed management card,
where dmc is the bottom distributed management
card and 1B is the bottom distributed management
card.
Log out of the current session.
u Change the existing password.
Chapter 2. The PMS daemon