Sun Microsystems Netra CT 820 Administration Manual page 33

2. Set the acceptable FRUs for the slot:
hostname cli> setfru fru_target fru_instance fru_field value
Refer to for allowable information for each variable. For example, if you
TABLE 2-1
want to set chassis slot 5 to allow only a Sun Microsystems (vendor 003E) particular
CPU board (part number 595-5769-03), enter the following:
hostname cli>
setfru slot 5 Acceptable_Fru_Types 003E:595-5769-03
Multiple boards can be specified for one slot. Separate the boards with a semi-colon.
You can also use the asterisk (*) as a wild card in the part number to allow multiple
boards. For example, if you want to set chassis slot 4 to allow only boards from three
particular vendors, with multiple board part numbers from one vendor, enter the
following:
hostname cli>
setfru slot 4 Acceptable_Fru_Types 003E:*;0004:1234-
5678-1;0001:8796541-02
3. Set the boot device for the slot:
hostname cli> setfru fru_target fru_instance fru_field value
Refer to for allowable information for each variable. For example, if you
TABLE 2-1
want to set chassis slot 5 to boot from a device on the network, enter the following:
setfru slot 5 Boot_Devices boot_device_list
hostname cli>
where boot_device_list is the alias(es) specifying the boot devices (limit is 25 bytes),
for example, disk net.
4. Completely power off and on the system by locating the power switch at the rear
of the Netra CT 820 server; press it to the Off (O) position, then press it to the On
(|) position.
Chapter 2 Configuring Your System 19