Sun Microsystems Netra CT 820 Administration Manual page 31

FRU ID Information Displayed Using the showfru Command (Continued)
TABLE 2-2
FRU
FRU Target Instance
slot 3 to 20
slot 3 to 20
switch 1 or 2
switch 1 or 2
switch 1 or 2
switch 1 or 2
fantray 1 to 3
fantray 1 to 3
fantray 1 to 3
fantray 1 to 3
M To Display FRU ID Information
1. Log in to the active distributed management card.
2. Enter the showfru command:
hostname cli>
FRU Field
Initial_HW_Rev_Level
Cust_Data
Sun_Part_No
Sun_Serial_No
Vendor_Name
Fru_Shortname
Sun_Part_No
Sun_Serial_No
Vendor_Name
Fru_Shortname
showfru fru_target fru_instance fru_field
Description
Display the initial hardware revision level of the
board in a particular slot.
Display any customer-supplied text for this field
for the board in a particular slot.
Display the part number for the specified
switching fabric board. FRU instance 1 is the
switch in slot 2; FRU instance 2 is the switch in
slot 21.
Display the serial number for the specified
switching fabric board. FRU instance 1 is the
switch in slot 2; FRU instance 2 is the switch in
slot 21.
Display the vendor name for the specified
switching fabric board. FRU instance 1 is the
switch in slot 2; FRU instance 2 is the switch in
slot 21.
Display the FRU short name for the specified
switching fabric board. FRU instance 1 is the
switch in slot 2; FRU instance 2 is the switch in
slot 21.
Display the part number for the specified fan
tray.
Display the serial number for the specified fan
tray.
Display the vendor name for the specified fan
tray.
Display the FRU short name for the specified fan
tray.
Chapter 2 Configuring Your System 17