A
A P P E N D I X
Third-Party Node Boards
Third-party cPSB-only node boards that are PICMG 2.16-compliant may be used in
the Netra CT 820 server. These boards do not necessarily run the Solaris Operating
Environment, and they do not run the Netra CT 820 server system management
software, such as MOH. Because of this, they cannot be managed to the same extent
as the Netra CP2300 cPSB board.
This appendix contains information on:
Third-Party Node Board FRU ID Information
I
CLI Commands Supported on a Third-Party Node Board
I
Third-Party Node Board FRU ID
Information
You can set and display certain FRU ID information for third-party node boards
using the CLI setfru and showfru commands.
To Configure a Chassis Slot for a Third-Party
M
Node Board
1. Log in to the active distributed management card.
67