Ctmgx Options - Sun Microsystems Netra CT 820 Administration Manual

4. As root, start the MOH application.
# cd /opt/SUNWnetract/mgmt3.0/bin
# ./ctmgx start [option]
If you installed the Solaris patches in a directory other than the default directory,
specify that path instead.
Options that can be specified with ctmgx start when you start the MOH
application include:

ctmgx Options

TABLE 2-4
Option
-rmiport portnum
-snmpport portnum
-snmpacl filename
-showversion
The MOH application starts and reads the configuration file using one of these
methods, in this order:
a. If the command ctmgx start -snmpacl
specified file as the ACL file.
b. If the file /opt/SUNWjdmk/jdmk4.2/etc/conf/jdmk.acl exists, MOH uses
that file as the ACL file when the command ctmgx start is used.
If the ACL cannot be determined after these steps, SNMP applications will have
read-write access and MOH will send the coldStart trap to the local node only.
Once MOH is running, it interfaces with your SNMP or RMI application to discover
network elements, monitor the system, and provide status messages.
Refer to the Netra CT Server Software Developer's Guide for information on writing
applications to interface with the MOH application.
Description
Specify the Remote Method Invocation (RMI) port number. The
default is 1099.
Specify the Simple Network Management Protocol (SNMP) port
number. The default is 9161.
Specify the SNMP ACL file to be used. The full path to filename
must be specified.
Print the system version number.
filename
is used, MOH uses the
Chapter 2 Configuring Your System 29