Recovery Configuration Of A Node Board From The Distributed Management Card - Sun Microsystems Netra CT 820 Administration Manual

Recovery Configuration of a Node Board From
the Distributed Management Card
You specify the recovery configuration of a node board by using the command pmsd
operset -s slot_num|all (a single slot number or all slots in the Netra CT system
containing a node board) and the recovery mode for the specified slot(s).
The recovery configuration can be maintenance mode, operational mode, or none
mode. Maintenance mode means the distributed management card's automatic
recovery of a node board is disabled, and PMS applications are started in an offline
state, so that you can use manual maintenance operations. Operational mode means
the distributed management card's automatic recovery of a node board is enabled;
the distributed management card will recover the node board in the event of a
monitoring fault, and start PMS applications in an active state. None mode means the
distributed management card's automatic recovery mode may be manually enabled
or disabled; PMS application states are not enforced.
The mode is stored in persistent storage. You specify the operation to be performed
on the specified slot by using the option -o with the parameter maint_config (set
the hardware, operating system, and applications into maintenance mode),
oper_config (set the hardware, operating system, and applications into
operational mode), none_config (set the hardware, operating system, and
applications into no enforcement mode), or graceful_reboot (bring the
applications offline if needed and then reboot the operating system).
To Specify the Recovery Configuration of a
M
Node Board
1. Log in to the distributed management card.
2. Configure the automatic recovery mode with the operset command:
hostname cli> pmsd operset -s slot_num|all -o
maint_config|oper_config|none_config|gracefulreboot
where slot_num can be a slot number from 3 to 20, and all specifies all slots
containing node boards. For example, to make PMS' recovery operational for the
entire Netra CT server, enter:
hostname cli> pmsd operset -s all -o oper_config
Chapter 3 Administering Your System 61