Table of Contents
Advertisement
Active Distributed Management Card Command-Line Interface Commands (Continued)
TABLE 3-1
Command
Type
Command
setdefaults
help
version
setdate [-h]
mmddHHMMccyy
setntpserver addr|none
setfru [-h] target instance
field value
showescapechar
Configuration
setipmode
(Ethernet
-b port_num
ports)
rarp|config|none
setipaddr
-b port_num addr
setipnetmask
-b port_num mask
setipgateway addr
Permis-
sion
Description
a
Initialize the distributed management card system
configuration variables, for example, the external
Ethernet port variables, to the defaults.
Display a list of supported commands.
Display the versions of various software and
firmware.
a
Set the current date.
a
Configure the distributed management card to be an
NTP client. The NTP server IP address must be on
the same subnet as the distributed management
card. The default is none.
a
Set FRU ID information. Refer to
CT Server FRU ID Information" on page 12
information.
This command is also supported on third-party
node boards. Refer to
for a Third-Party Node Board" on page 67
information.
a
Show the escape character used to end a console
session.
a
Set the IP mode of the specified Ethernet port.
Choose the IP mode according to the services
available in the network (rarp, config, or none).
The default for the external Ethernet port is none;
the default for the internal Ethernet port is none,
that is, no services are available on this port. You
must reset the server for the changes to take effect.
a
Set the IP address of the specified Ethernet port. The
default is 0.0.0.0. This command is only used if the
ipmode is set to config. You must reset the server
for the changes to take effect.
a
Set the IP netmask of the specified Ethernet port.
The default is 0.0.0.0. This command is only used if
the ipmode is set to config. You must reset the
server for the changes to take effect.
a
Set the IP gateway of the distributed management
card. The default is 0.0.0.0. You must reset the server
for the changes to take effect.
Chapter 3 Administering Your System
"Specifying Netra
for more
"To Configure a Chassis Slot
for more
41
Advertisement
Table of Contents
