To Remove And Replace The Hp-Ib And Rs-232C Cables - HP 1660 Series Service Manual

Replacing Assemblies

To remove and replace the HP-IB and RS-232C cables

To remove and replace the HP-IB and RS-232C cables
Using previous procedures, remove the following assemblies:
1 1
•
Handle
•
Rear Feet
•
Cover
•
Disk Drive
•
Power Supply
•
Rear Panel
Remove the two hex standoffs connecting the HP-IB cable, then slide the HP-IB
2 2
cable forward and out of the rear panel.
Remove the two hex standoffs connecting the RS-232C cable, then slide the RS-232C
3 3
cable forward and out of the rear panel.
Reverse this procedure to install the HP-IB and RS-232C cables.
4 4
6–14