HP 1660 Series Service Manual page 36

Testing Performance
To make the test connectors (logic analyzer)
Build one test connector using a BNC connector and a 17-by-2 section of Berg strip.
2 2
a a Solder a jumper wire to all pins on one side of the Berg strip.
b b Solder a jumper wire to all pins on the other side of the Berg strip.
c c Solder the center of the BNC connector to the center pin of one row on the Berg strip.
d d Solder the ground tab of the BNC connector to the center pin of the other row on the
Berg strip.
3–7