Table of Contents
Advertisement
LINE-UP PLATE
(INSERT INTO VERTICAL SLOT)
LINE-UP TAB
(AT BACK OF BUMPER)
FRONT CASE BOLT
(UPPER 3/8" HOLE)
FRONT BODY PANEL REMOVED
FOR ACCESS TO FRONT CASE BOLTING
Location
The refrigerated merchandisers have been designed
for use only in air conditioned stores where temperature
and humidity are maintained at or below 75°F and 55%
relative humidity. DO NOT allow air conditioning, electric
fans, ovens, open doors or windows (etc.) to create air
currents around the merchandiser, as this will impair its
correct operation.
Product temperature should always be maintained at a
constant and proper temperature. This means that from the
time the product is received, through storage, preparation
and display, the temperature of the product must be
controlled to maximize life of the product.
Q-Series Joining Guide
LINE-UP PLATE
(INSERT INTO ALUMINUM PROFILE)
Q SERIES CASE JOINING GUIDE
Installation
Uncrating the Stand
Place the fixture as close to its permanent position as
possible. Keep in place, attached case until ready to set/bolt
to adjoining case.
Tighten Glass Screws
Tighten screws along clamshell located on the underside
of glass before placing unit into operation.
Exterior Loading
These models have not been structurally designed to
support excessive external loading. Do not walk on their
tops; This could cause serious personal injury and damage
to the fixture.
3
CASE BOLTING
USE 1/4"- 20 X 1 1/2" SCREW AT TOP
LINE-UP PIN
(INSERT INTO OUTER 1/2" HOLE)
CASE BOLTING (MULTIPLE 3/8" HOLES)
ACCESS BEHIND AIR DISCHARGE WALL
Advertisement
Table of Contents
