Canon 1100 Reference Manual page 203

3
Load the stack of paper into the paper deck, with the surface of the paper
that was facing upward when the package was opened placed face up.
Make sure that the lifter has lowered before loading the paper. Stack paper neatly against the inner
paper guide.
IMPORTANT
•
If the paper is curled, curl it down before placing it into the paper deck.
•
Make sure that the height of the paper stack does not exceed the loading limit (
•
Do not load the following types of paper into the paper deck. Doing so may cause a paper jam.
- Severely curled or wrinkled paper
- Thin straw paper
- Transparencies
- Paper that has been previously copied onto by this copier (do not copy on the reverse side either)
- Paper that has been output using a printer or a copier other than this copier (do not copy on the
reverse side either)
•
Always use the stack bypass to feed paper when you copy onto the rear side of a sheet of paper that
already has something copied onto its front side (2nd side of 2-sided copy).
•
Fan the stack of paper well before loading it.
•
Do not place paper or any other items in the empty part of the paper deck. Doing so may cause
paper jams.
) mark.
5-31
Paper Deck-E1
5