Obtain Nw User Property - Kyocera ECOSYS M2040dn Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

Obtain NW User Property

Set the required information to obtain the network user property from the LDAP server. The user name obtained with this
setting is shown in the user information, the status confirmation screen, and the header of E-mail.
NOTE
• To obtain the network user property from the LDAP server, [Netwk Authentic.] must be selected for the
authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "ProtocolSettings".
Enabling User Login Administration (page 9-3)
ProtocolSettings (page 8-12)
• Setting to obtain network user information is performed from the operation panel. The details of the information to be
obtained should be set with Command Center RX.
Command Center RX User Guide
1
2
Display the screen.
1
[System Menu/Counter] key > [▲] [▼] key > [User/Job Account] > [OK] key
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and select [Login]. For this, you need to login with administrator privileges.
The factory default login user name and login password are set as shown below.
Model Name
ECOSYS M2135dn/ECOSYS
M2635dn/ECOSYS M2635dw
ECOSYS M2040dn/ECOSYS
M2540dn/ECOSYS M2540dw
2
[▲] [▼] key > [User Login Set.] > [OK] key
Configure the settings.
[▲] [▼] key > [NW User Property] > [OK] key > [▲] [▼] key > [Off] or [On] > [OK] key
Login User Name
3500
4000
9-19
Login Password
3500
4000