Pentair FLECK 5810 XTR Installer Manual page 54

Installer Manual Fleck 5810 - XTR - Programming
17. USB connect
18. Arrows
Note
Settings on previous screen are not saved unless
19. Alarm
20. Error
21. Error log
22. Advance
23. Reset
24. Non-factory
settings
25. Brightness
54 / 124
→ Allows you to connect the controller to a PC via a USB cable
for field programming or download of diagnostic
parameters via PC (Field Programmer application
required).
→ Displayed in the upper-left and upper-right corners of the
screen, these arrows allow you to navigate from one screen
to another.
→ Allow you to change the values of certain settings when
programming the controller.
→ Displayed when an error has occurred; accompanied with an
audible alarm. Press to silence the audible alarm.
→ Displayed when an error has occurred. Press to display the
error screen for more detailed error information.
→ Press to show error list with date and time.
→ This arrow allows you to advance through cycle steps during
a regeneration.
→ Displayed in the diagnostics screen by pushing on totalizer
and peak flow buttons to reset totalizer and peak flow data,
and in master settings screen to reset parameters to
factory or non-factory settings.
→ Press to save all the configuration in a custom profile.
→ Displays the brightness screen, to adjust the backlight
brightness of the controller screen.
is pressed.
Ref. MKT-IM-018 / C - 08.06.2018