Table of Contents
Advertisement
Installer Manual Fleck 5810 - XTR - Maintenance
9.2.7. Injector cleaning
No.
A
Remove the injector block clip (1) using a flat screwdriver on the dedicated slot (2).
B
Remove the injector cap (6) using a flat screwdriver on the dedicated slot (7).
C
Using the injector block clip (1), remove the injector (8).
Caution
To avoid any damage on the injector, use only the clip to remove it.
D
Remove the screen (4) using pliers.
E
Using the injector block clip (1), remove the injector plug (3).
F
Clean or change the injector (8), the screen (4), the injector plug (3) and the seal (5).
G
Lubricate all seals with approved silicone lubricant only.
H
Reverse above procedure steps to rebuild.
106 / 124
Operation
Ref. MKT-IM-018 / C - 08.06.2018
Advertisement
Table of Contents
