Rops Assembly Replacement - Toro Z MASTER 2000 Series Service Manual

Fuel Tank Installation (continued)

ROPS Assembly Replacement

ROPS Removal
Chassis: Service and Repairs
g420401
8. Install the seat. Refer to
9. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Using a 1/2 inch socket, remove the 2 (5/16 inch) nuts and carriage bolts
securing the rear of the seat to the chassis.
4. Lift the seat forward and disconnect the seat pressure switch from the wire
harness.
5. Remove the 2 hair pins and ROPS fold pins. Lower the upper ROPS to
the full-down position.
Figure 69
Seat Installation (page
Page 6–12
6–16).
2000 Series Z MASTER®Service Manual
3460-328 Rev A