Toro Z MASTER 2000 Series Service Manual page 106

Hydrostatic Drive Belt Replacement
Hydrostatic Drive Belt Removal
Drive: Service and Repairs
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Using a floor jack, raise the rear of the machine and secure it with jack stands.
4. Remove the deck belt. Refer to
5. Using a 1/2 inch breaker bar, rotate clockwise to release tension on the
spring.
g420403
6. Remove the belt from the clutch. Remove the hydrostatic belt.
Deck Belt Removal (page
Figure 110
Page 7–10
5–7).
2000 Series Z MASTER®Service Manual
3460-328 Rev A