Toro Z MASTER 2000 Series Service Manual page 105

LH & RH Control Assembly Installation (continued)
2000 Series Z MASTER®Service Manual
3460-328 Rev A
3. Using a 1/2 inch socket, install the (1/2 inch) nut to secure the LH & RH
motion control linkages to the transaxle assembly. Torque to 22 ± 3 N•m
(200 ± 25 in-lb).
Note: For the LH side: Connect the parking brake linkage to the parking
brake handle and install the pin to secure the parking brake linkage to the
handle.
g421530
4. Install the neutral safety switches. Connect the wire harness to the LH &
RH neutral safety switches.
g421553
5. Using a T40 torx driver, install the 4 (5/16 inch) bolts to secure the LH & RH
mounting brackets to the chassis.
6. Using a T40 torx driver, install the 4 (5/16 inch) bolts to secure the LH &
RH pod tubes to the chassis.
7. Install the LH & RH pods. Refer to
and Right Hand Pod Installation (page
8. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 108
Figure 109
Left Hand Pod Installation (page 6–21)
6–23).
Page 7–9 Drive: Service and Repairs